Sony DCR-SR32E Manual page 36

5. CAMERA Adjustment 2
(Using the flange back adjustment chart and
subject more than 500 m away)
5-1. CAMERA Adjustment 2 (1)
[Automatic Adjustment Program execution items and
sequence]
1. Data Setting during Camera Adj.
2. Flange Back (1) Adj.
3. Release of Data Setting during Camera Adj.
[Preparation]
1) Place the Flange back adjustment chart at 2 m position away
from the lens.
2) Check that the center of Flange back adjustment chart meets
the center of shot image screen with the zoom lens at TELE
end and WIDE end respectively.
[Adjusting method]
1) Click the [Start $1%] button of the CAMERA Adjustment 2.
2) The Automatic Adjustment Program executes "1. Data Setting
during Camera Adj.".
3) Upon successful completion of the "1. Data Setting during
Camera Adj.", the following message is displayed. Set the sub-
ject by referring to "Preparation".
4) If the [OK] button is clicked, "2. Flange Back (1) Adj." and "3.
Release of Data Setting during Camera Adj." will be executed.
5) Upon successful completion of all items of the CAMERA
Adjustment 2 (1), the following message is displayed. Click
the [OK] button.
6) Perform "CAMERA Adjustment 2 (2)".
DCR-SR32E/SR33E/SR42/SR42A/SR42E/SR52E/SR62/SR62E/SR72E/SR82/SR82C/SR82E_ADJ
5-2. CAMERA Adjustment 2 (2)
[Automatic Adjustment Program execution items and
sequence]
1. Data Setting during Camera Adj.
2. Flange Back (2) Adj.
3. Release of Data Setting during Camera Adj.
[Preparation]
1) Set the zoom lens to the TELE end and expose a subject that is
more than 500 m away.
(subjects with clear contrast such as building, etc.)
(Nearby subjects less than 500 m away should not be in the screen)
[Adjusting method]
1) Click the [Start $2%] button of the CAMERA Adjustment 2.
2) The Automatic Adjustment Program executes "1. Data Setting
during Camera Adj.".
3) Upon successful completion of the "1. Data Setting during
Camera Adj.", the following message is displayed. Set the sub-
ject by referring to "Preparation".
4) If the [OK] button is clicked, "2. Flange Back (2) Adj." will be
executed.
The following message is displayed during the execution of
adjustment, and then place the ND filter on the lens so as to
obtain the optimum image.
5) If "2. Flange Back Adj." completed successfully, "3. Release
of Data Setting during Camera Adj." will be executed.
6) Upon successful completion of all items of the CAMERA
Adjustment 2 (2), the following message is displayed. Click
the [OK] button.
6-34
Ver. 1.7 2008.04