Sony DCR-SR32E Manual page 13

1. HDD Replacement Procedure
Note: During the execution of Factory Check, the LCD screen of
the camcorder becomes gray.
When the Factory Check finished, the LCD screen changes
as follows:
When Factory Check is OK: Camera image display
When Factory Check is NG: Blue display
Connect the camcorder to the PC
with a USB cable, and turn on the
power switch.
The USB SELECT menu will appear
on the LCD screen of the camcorder,
and the select "COMPUTER" to
establish the connection.
Execte the "CheckHDDError.vbe".
(Double-click the file.)
Message is checked.
When message is
"No Error"
Replacing the HDD is unneccessary.
DCR-SR32E/SR33E/SR42/SR42A/SR42E/SR52E/SR62/SR62E/SR72E/SR82/SR82C/SR82E_ADJ
Start
When message is
"Error Detected"
End
Yes
New HDD
Is replacement HDD new one?
Execte the
"SetFactoryCheckDefault.vbe".
(Double-click the file.)
Wait until "JOB Success"
message is displayed.
(several seconds)
Turn off the power of camcorder.
Replace the HDD.
Turning on the power of camcorder
will start automatic Factory Check.
Wait until Factory Check completed. (Note)
[EST. PROCESS TIME]
Default: 6 min.
Full:
Turn off the power and turn on again.
"Manegement file damaged.
Create new file?" will appear
on the LCD screen of the camcorder,
and the select [YES].
Execte the
"ExecAfterFactoryCheck.vbe".
(Double-click the file.)
Wait until "JOB Success"
message is displayed.
(several seconds)
6-11
No
Reused HDD
Execte the
"SetFactoryCheckFull.vbe".
(Double-click the file.)
Wait until "JOB Success"
message is displayed.
(several seconds)
1 hour 58 min.