Error Reporting - Hitachi Deskstar 7K500 Specifications

5.44.8 Error reporting

The following table shows the values returned in the Status and Error Registers when specific error conditions are
encountered by a device.
Table 104: S.M.A.R.T. Error Codes
A S.M.A.R.T. FUNCTION SET command was received by the device
without the required key being loaded into the Cylinder High and Cylin-
der Low registers.
A S.M.A.R.T. FUNCTION SET command was received by the device
with a subcommand value in the Features Register that is either invalid
or not supported by this device.
A S.M.A.R.T. FUNCTION SET command subcommand other than
S.M.A.R.T. ENABLE OPERATIONS was received by the device while
the device was in a "S.M.A.R.T. Disabled" state.
The device is unable to read its Attribute Values or Attribute Thresholds
data structure
The device is unable to write to its Attribute Values data structure.
Error condition
Deskstar 7K500 Hard Disk Drive Serial ATA Addendum
Status Register
152
Error Register
51h 04h
51h 04h
51h 04h
51h 10h or 40h
51h 10h or 01h