Advertisement
ADJUSTING THE HEIGHT
The dishwasher must be leveled and balanced after it is placed into the cabinetry enclosure. Prior to it being
placed in the final position, the leveling legs should be at the shortest position. There are 2 sets of leveling
legs that are included with dishwasher. Carefully measure the height of the enclosure to determine which
legs you should use.
NOTE: Carefully measure the height of the enclosure to make sure you are using the correct legs to assure
that the top of the dishwasher is flush with hte bottom of the counter.
• If the height of the enclosure is 33 7/8" to 35 7/8" (860mm-910mm) use short leveling legs that come
on the unit.
• If the height of the enclosure is above 35 7/8" (910mm) use the Long Legs included in the parts bags.
Once inserted into the enclosure, raise the leveling feet until the top of the dishwasher is flush with the
underside of the counter-top. Check that the unit is plumb and level and adjust the leveling feet as needed:
1. Adjust the front legs up or down using a slotted screwdriver to raise or lower the legs.
2. Adjust the rear legs using the Philips screw located at the bottom of the dishwasher in the center.
8
Figure 3
Advertisement
