Earbuds Pairing/Connecting - K-Mate BTH171Q Manual

4.Earbuds pairing/connecting

Please use this step if two headset can not be connect with each
other.
1.Turn off two earbuds respectively(don't put them into the charging case).
2.Clear the pairing list: Choose one of the earbuds. Firstly, enter the pairing
mode.Then hit the touch button 5 times, while the red LED and the white
LED turns on for 1 second. The pairing list will be cleared when emits
prompt tone. The other headset cleans the pairing list by doing the same.
3.The earbuds will enter TWS pairing mode automatically when they are
turned on (indicator light status: red and white lights flash slowly).After
successful connection, the master earbud(L) will emits"Pairing" after a
"dang"prompt, which indicator light status will be: red LED and white LED
flash alternately(it keeps waiting to be paired with your phone), while the
slave earbud(R) will emits 'Dang' and indicator status will be: white LED
flash twice time every 5 seconds.
Remarks:
In normally the two earbuds will connect automatically once you have
◆
taken out of the charging case,which set in factory.
You can connect the two earbuds according above operation if they failed
◆
connecting.
6