Table of Contents
Advertisement
2.2 Cellular Antennas
Main (ANT) and diversity (DIV) antennas can be connected to the router using the SMA
connectors located on the front panel.
Do not run the router without connected cellular antenna connected to the main antenna
connector as the energy from the transmission is effectively reflected by the open end
and can damage the equipment.
Recommended tightening moment for screwing the antenna to the SMA connector is 0.9 Nm.
The diversity antenna improves the radio capability of the router at low signal strength.
2.3 Ethernet Interfaces
The panel socket of RJ45 is used for Ethernet interface. The pinout of the socket is shown
in Figure
6
and described in Table 3.
Pin
1
2
3
4
5
6
7
8
The isolation barrier of the Ethernet ports against the ground is 1500 V.
LUCOM GmbH — Flößaustr. 22a — 90763 Fürth — Tel.: +49 911/ 957 606 00 — E-Mail: info@lucom.de — www.lucom.de
Figure 6: Ethernet Connector Pinout
Signal mark
Description
TXD+
Transmit Data – positive pole
TXD-
Transmit Data – negative pole
RXD+
Receive Data – positive pole
—
—
—
—
RXD-
Receive Data – negative pole
—
—
—
—
Table 3: Ethernet Connector Pinout Description
15
ICR-2734
Advertisement
Table of Contents
