Fisher FSK-180B-EU Operating And Installation Instruction Manual page 30

Setting temperature range under each mode:
HEAT -------- 16℃～30℃
COOL -------- 16℃～30℃
DRY
-------- 16℃～30℃
FAN -------- can not be set
Auto mode is divides into new auto mode and old auto mode.
NEW AUTO MODE --------------16℃～30℃
OLD AUTO MODE ---------- can not be set
4）Swing Setting (Fig.7)
Press SWING button, SWING will be displayed on the
LCD, in which case, the unit is under swing status.
Press this button again, the words will disappear and the
unit stops swinging.
Note: Sleep function can be set by remote controller.
5）Running Mode Setting (Fig.8)
Every press of mode button, the operation mode will
change as follow:
→COOL→DRY→FAN→ HEAT → AUTO
In cool mode, COOL will light, in which case, setting
temperature should be set to be lower than present ambient
temperature; If not, the unit will not operate in cool mode
and only the fan is active.
In dry mode, DRY will light .Indoor fan will run at low speed
in certain temp. range. Dry efficiency as well as energy
saving efficiency in this mode is much better than that in
cool mode
In heat mode, HEAT will light. The setting temperature
should be set to be higher than present ambient
temperature; if not, the unit can not operate in heat mode.
In fan mode, FAN will light.
In auto mode, AUTO will light and the unit will run at the
mode automatically adjusted according to ambient temp.
In heating mode, if outdoor temp is low with high humidity,
27
TIMER
Fig.7
TIMER
Fig. 8