Fisher FSK-180B-EU Operating And Installation Instruction Manual page 13

buttons to set cooling temperature upper limit, it will flash and display at ambient temperature,
( the setting range is 16-30) , and press "ON/OFF" button to confirm.
NOTE:The upper limit temperature should not be lower than the setting lower limit temperature.
If upper limit temperature is lower than the lower limit temperature, the system will default. The
higher is the upper limit temperature, the lower is the lower limit temperature. Press "MODE"
button, to complete the save setting in COOL, DRY mode, and transfer to the save setting in
HEAT mode (There is no the function in cooling only unit), at this time, it displays the "SAVE",
"HEAT" icons, after setup has been completed, then press "FAN" +"▼" button last for 5 seconds,
and quit the SAVE setting operation. If the SAVE interface has been opened, the system will
respond to the last button input after 20 seconds, there is no any operation, the system will quit
the menu, and displays the normal unit off interface.
The above setting has been completed, the system will display "SAVE" icon, no matter
by buttons on displayer or the wireless remote control, the setting temperature should not
exceed the former SAVE setup temperature range, for example as show in Fig. 9, we set up
the cooling lower limit is 23℃ in SAVE setting, the upper limit is 27℃ , the user can set the
cooling temperature between 23℃ to 27℃ by the wireless remote control and buttons on
displayer.
If the set up upper limit temperature is the same with the lower limit temperature that the
system only can run at the corresponding modes at the set temperature.
After the SAVE mode set up, at unit turned off, press the "FAN" +"▼" buttons for 5 seconds,
will quit the SAVE setting function, but the former
setting data will not clear, and the next time SAVE
setting will be the initial setting temperature.
After powered off, the SAVE setup function will be
memorized, the next time power on, the SAVE setting
is still active.
Set up the SAVE mode, the SLEEP, AUTO modes
will shield.
10
MODE
FAN
SWING
TIMER
ON/OFF
Fig 10