Error Reporting - Cisco 1700 Manual

Appendix B ROM Monitor

Error Reporting

78-5407-03
Argument
y
r
x
destination_file_name
Because the ROM monitor console download uses the console to perform the data
transfer, error messages are displayed on the console only when the data transfer
is terminated.
If an error does occur during a data transfer, the transfer is terminated, and an
error message is displayed. If you have changed the baud rate from the default
rate, the error message is followed by a message telling you to restore the terminal
to the baud rate specified in the configuration register.
Description
Optional. Sets the router to perform the download
using ymodem protocol. Default is xmodem protocol.
The protocols differ as follows:
The xmodem protocol supports a 128-block
•
transfer size, whereas the ymodem protocol
supports a 1024-block transfer size.
The ymodem protocol uses 16-bit CRC error
•
checking to validate each packet. Depending on
the device that the software is being downloaded
from, this function might not be supported by the
xmodem protocol.
Optional. Image is loaded into DRAM for execution.
Default is to load the image into Flash memory.
Optional. Image is loaded into DRAM without being
executed.
The name of the system image file or the system
configuration file. In order for the router to recognize
it, the name of the configuration file must be
router_confg.
Cisco 1700 Series Router Software Configuration Guide
Console Download
B-11