Package Contents - Stanley STHR323 Manual

ENGLISH
(Original instructions)
LABELS ON TOOL
The label on your tool may include the following symbols:
WARNING! To reduce the risk of injury, the user
must read the instruction manual before use.
Wear safety glasses or goggles.
Wear ear protection.
V Volts
A Amperes
Hz Hertz
W Watts
min minutes
Alternating
Current
Position of Date Code
The Date Code, which also includes the year of manufacture,
is printed into the housing.
Example:
2017 XX JN
Year of manufacturing

PACKAGE CONTENTS

The package contains:
1 SDS-Plus rotary hammer
1 Side handle
1 Depth stop
1 Instruction manual
• Check for damage to the tool, parts or accessories which
may have occurred during transport.
• Take the time to thoroughly read and understand this
manual prior to operation.
FEATURES (Fig A)
This tool includes some or all of the following features.
1. On/Off switch
2. Speed selector dial
3. Drilling mode selector
4. Operating mode selector
5. Tool holder
6. Side handle
7. Depth stop
8. Grease cap
6
Direct Current
n No-Load Speed
0
Class II Construction
Earthing Terminal
Safety Alert Symbol
Revolutions or
/min. Reciprocation per
minute
ASSEMBLY
WARNING! Before assembly, make sure that the
tool is switched off and unplugged.
Fitting the side handle (Fig A)
• Turn the grip counterclockwise until you can slide the side
handle (6) onto the front of the tool as shown.
• Rotate the side handle into the desired position.
• Tighten the side handle by turning the grip clockwise.
Fitting and setting the depth stop (Fig A)
• Slacken the knob (9).
• Insert the depth stop (7) into the mounting hole as shown.
• Set the depth stop (7) to the desired position. The
maximum drilling depth is equal to the distance between
the tip of the drill bit and the front end of the depth stop.
• Tighten the knob (9).
Fitting an accessory (Fig B - D)
• Clean and grease the shank (10) of the accessory.
• Pull back the sleeve (11) and insert the shank into the tool
holder (5).
• Push the accessory down and turn it slightly until it fits into
the slots.
• Pull on the accessory to check if it is properly locked. The
hammering function requires the accessory to be able to
move axially several centimetres when locked in the tool
holder.
• To remove the accessory, pull back the sleeve (11) and
pull out the accessory.
Keyed chuck (Fig D)
• Open the chuck by turning the sleeve (12) anti-clockwise.
• Insert the bit shaft (13) into the chuck.
• Insert the chuck key (14) into each hole (15) in the side of
the chuck and turn clockwise until tight.
USE
WARNING! Let the tool work at its own pace. Do
not overload.
WARNING! Before drilling into walls, floors or
ceilings, check for the location of wiring and pipes.
WARNING! Do not apply chisels when the tool is in
the drilling mode.
Selecting the operating mode (Fig F)
The tool can be used in three operating modes.
• To operate the drilling mode selector (3), rotate it towards
the required position, as indicated by the symbols.
• To operate the operating mode selector (4), push the
unlock button (16) and rotate the selector towards the
required position, as indicated by the symbols.
Drilling
• For drilling in steel, wood and plastics, and for
screwdriving set the operating mode selector (4) to the
position and the drilling mode selector (3)to the position.