Assigning Remote Controls; Programming The Remote Control's Buttons - Paradox Magellan MG-6130 Reference And Installation Manual

The signal strength can also be verified by performing a
system test. See Quick Setup on page 4 for more
information.

Assigning Remote Controls

The Magellan console accepts up to 16 fully programmable
remote controls. Every User code can have one remote control
assigned to it.
To assign a remote control:
MENU
1. Press [ ] + [4] + [2].

Programming the Remote Control's Buttons

Sections [041] to [056]: Users 1 to 16; Remote Controls 1 to 16
Sections [041] to [056] represent the remote controls assigned to
User codes 1 to 16 (see table below).
Warning: When section [040] is accessed, the console will copy the saved value of that section to all remotes.
Section RC# Data (Default: 4DE0)
[040] 1-16 ______
Default
[041] 1 ______
[042] 2 ______
[043] 3 ______
[044] 4 ______
[045] 5 ______
[046] 6 ______
[047] 7 ______
[048] 8 ______
20
Programming the MG-REM1/MG-REM2
______ ______ ______
______ ______ ______
______ ______ ______
______ ______ ______
______ ______ ______
______ ______ ______
______ ______ ______
______ ______ ______
______ ______ ______
The remote control will transmit a signal for only 1 second when
a button is pressed and held for 1 second. This is done to
conserve the remote control's batteries.
Although remote controls can be assigned by the System
Master, the remote control's buttons are programmed by the
installer.
Each remote control can be programmed to perform different
actions. Each digit in sections [041] to [056] represents a button
or combination of buttons (see table below).
To program a remote control's buttons:
1. Access the installer programming mode (see page 13).
2. Enter the [
SECTION
to the desired remote control.
3. Enter the [
HEXADECIMAL VALUE
option from the Button Options Table on page 23.
If you do not wish to program all the buttons or button
combinations, press the [#] key at any time to save and exit.
If you enable any Panic button options, you must enable the
Panic options in the control panel (refer to Panic Alarms on
page 26).
Section RC#
+
+
[049] 9
[050] 10
[051] 11
[052] 12
[053] 13
[054] 14
[055] 15
[056] 16
] (sections [041] to [056]) corresponding
] (0 to F) of the desired button
Data (Default: 4DE0)
______ ______ ______
______ ______ ______
______ ______ ______
______ ______ ______
______ ______ ______
______ ______ ______
______ ______ ______
______ ______ ______
Reference & Installation Manual
+
+
______
______
______
______
______
______
______
______