Decorative Trim Plate; Mounting - Bryant Evolution Connex Control Installation Instructions Manual

Hide thumbs Also See for Evolution Connex Control:

Table of Contents

4.5.

Decorative Trim Plate

Sold separately, a thin decorative trim plate is available to hide any marks/screw

holes left from the previous thermostat. The trim plate is captured between the

backplate and the system control. Align the trim plate around the backplate, and

snap on the system control.

A12213

NOTE: Once the Evolution Connex Control is secured to wall with the backplate

assembly (snapped together), care must be taken not to bend or break the

interlocking tabs when removing.

4.5.1

First become familiar with all plastic assembly pieces shown on the following page.

The Evolution Connex Control will snap together with the standard backplate

supplied with the wall control. Attach backplate using only a small hole in the wall

allowing a four wire connection to pass through. Mount the front assembly to the

standard backplate. The figure below shows the optional decorative trim plate

installed with the standard backplate, described in Section 4.5.1. The trim plate is

Table of Contents

Show Quick Links

Table of Contents

Do you have a question about the Evolution Connex Control and is the answer not in the manual?

Systxbbecc01-b