Basic Functions; Led Functions For The Sackit Active 200 Case; Led Funktioner For Sackit Active 200 Earbuds; Troubleshooting - SACKit Active 200 User Manual

BASIC FUNCTIONS

Left earbud
Volume down - 1 tap
Previous song - Hold for 2 sec
Play/pause - 2 taps
Bass mode on/off - Hold for 3 sec
Answer/end call - 2 taps

LED FUNCTIONS FOR THE SACKIT ACTIVE 200 CASE

When earbuds charge in the case
1 blink - 0-25% power on the case
2 blink - 25-50% power on the case
3 blink - 50-75% power on the case
4 blink - 75-100% power on the case
LED off - fully charged earbuds

LED FUNKTIONER FOR SACKIT ACTIVE 200 EARBUDS

When earbuds are charging in case
Red blinks - earbuds are charging
LED off - earbuds are fully charged

TROUBLESHOOTING

1. Reset SACKit Active 200 if the earbuds cannot connect to each other
2. Reset by placing both earbuds in the charger box and holding down both earbuds buttons until the
red LED goes out. Then hold down both earbuds buttons for 10 seconds until one earbud flashes red/
white.
3. You can now reconnect SACKit Active 200 to your device
4. If you are experiencing issues with stability or connection try removing the pairing between your
device and SACKit Active 200. Choose Bluetooth settings on your device and forget SACKit Active
200. Pair again as described in 'Use SACKit Active 200 earbuds'
Right earbud
Volume up - 1 tap
Next song - Hold for 2 sec
Play/pause - 2 taps
Bass mode on/off - Hold for 3 sec
Answer/end call - 2 taps
When the casse charges with plug / wireless
1 blink - 0-25% power on the case
2 blink - 25-50% power on the case
3 blink - 50-75% power on the case
4 blink - 75-100% power on the case
LED on - fully charged case
When earbuds are in use
White blinks - earbuds paired with a device
White/red blinks - pairing mode
4 red blinks each minute - earbuds needs charging
7