Advertisement
1) After you have completely configured your Range Extender you can
disconnect the Ethernet cable that connects the Extender to your network or
PC for configuration.
2) Take the Range Extender and Power Adapter and place the Extender in a
location half way between your original Access Point and the area that you are
extending your wireless coverage to. See the image below for more details:
4)Test the Range Extender by connecting to it wirelessly with a wireless
enabled computer. Give the computer 15 seconds to obtain information from
the Range Extender after associating to the Range Extender's SSID. Open
your web browser and enter
If the page loads your Wireless Range Extender is working correctly. If not
please check the troubleshooting section or reconfigure your Wireless Range
Extender.
www.hawkingtech.com
3) Once you have
located a good location,
plug the power adapter
into an available power
outlet and view the
LEDs on the Range
Extender. If the
Range Extender is
working the WLAN light
should be blinking
repeatedly and the
PWR LED should
remain on constantly.
into the web address bar.
11
Advertisement
