Table of Contents
Advertisement
Setting
Setting - <Setting> - <System> - CamSeri
3.5 Enabling/disabling camera
serial communication
Auto recognition of the camera-lens interface can be enabled or
disabled (analog control).
<System>
System screen
I G :
5 0
Indicator:
ON
Tally:
ON
Cafs:
ON
× 5
<System>
I G :
5 0
VR-Out:
OFF
CamSeri:
ON
TalBrtness:
62
OFF
to select
Selection item
ON
(D)
Function
Enabled
BT1-D005-A-ENG
Setting - <Setting> - <System> - TalBrtness
3.6 Setting tally brightness
System screen
Selection item
Function
OFF
Disabled
(D): Default value
<System>
I G :
5 0
Indicator:
ON
Tally:
ON
Cafs:
ON
× 6
<System>
I G :
5 0
CamSeri:
ON
TalBrtness:
62
LensCode: 0000
OFF
to adjust
01
–
99
Dimmest
Brightest
Default value: 62
©2022.04 CANON INC.
Setting - <Setting> - <System> - LensCode
3.7 Setting the lens code
After you assign a number (code) to the lens, it can be sent to
the camera. Choose from 16 different codes in binary format,
0000–1111.
Depending on camera functions, these codes may be used to
enable cameras to identify lenses.
Set if instructed to do so by the camera manufacturer.
<System>
System screen
I G :
5 0
Indicator:
ON
Tally:
ON
Cafs:
ON
× 7
<System>
I G :
5 0
CamSeri:
ON
TalBrtness:
62
LensCode:
0000
to adjust
Note
• 16 different codes in binary format are shown as you cycle through the setting option.
• The lens code remains the same if settings are reset.
Selection item
0000
Default value: Set at the factory before shipment.
–
1111
9/20
Advertisement
Table of Contents
