Adjusting The Carburetor - Stihl BG 45 Instruction Manual

english / USA
5
4
3
:
Take the foam element (3) out of the
filter cover (2).
:
Take the felt element (4) out of the
filter housing (5).
:
Wash the foam element in a clean,
non-flammable solution (e.g. warm
soapy water) and then dry.
:
Install a new felt filter element . As a
temporary measure you can knock it
out on the palm of you hand or blow
it out with compressed air - do not
wash!
:
Replace any damaged parts.
16
:
Fit the foam element (3) in the filter
cover (2).
:
Fit the felt element (4) in the filter
housing (5).
:
Fit the filter cover (2) so that it snaps
into positon.
2

Adjusting the Carburetor

LD
+
-
Motor Management
Exhaust emissions are controlled by
the design of the fundamental engine
parameters and components
(e.g. carburation, ignition, timing
and valve or port timing) without the
addition of any major hardware.
The carburetor has been adjusted for
optimum performance and fuel
efficiency in all operating states at
the factory.
BG 45