Stiga MPST 84 Li 48 V1 Quick Manual For Use page 79

PROBLEM
The icon in fig. 13.E remains ON and
battery LEDs 1, 4 and 5 flash.
Pushbutton panel type "I" and "II"
Pushbutton panel of type "III"
The icons in fig. 13.E and fig. 13.O
remain ON, battery LEDs 1 and 3 flash.
Pushbutton panel type "I" and "II"
Pushbutton panel of type "III"
The icon in fig. 13.E remains ON and
battery LEDs 1, 3 and 5 flash.
Pushbutton panel type "I" and "II"
Pushbutton panel of type "III"
The icons in fig. 13.E and fig. 13.O
remain ON, battery LEDs 1, 2 and
4 flash.
Pushbutton panel type "I" and "II"
Pushbutton panel of type "III"
Cause
Current overload to cutting means
caused by:
Work conditions too demanding.
Obstructions that prevent rotation of the
cutting means.
The cutting means assembly is full
of grass
Cutting means motor over-temperature
caused by:
Work conditions too demanding.
Cutting means motor stall caused by:
Work conditions too demanding.
Obstructions that prevent rotation of the
cutting means.
The cutting means assembly is full
of grass
Drive motor over-temperature caused
by:
Drive motor under stress.
Slope too steep .
Excessive mud on the wheels.
EN - 10
Solution
Reduce forward speed:
Increase the cutting height:
Remove the obstructions.
Clean the cutting means assembly.
Turn off the machine, wait for at least 5
minutes and then restart it.
Reduce forward speed:
Increase the cutting height:
Reduce forward speed:
Increase the cutting height:
Remove the obstructions.
Clean the cutting means assembly.
Switch off the machine and wait for at
least 5 minutes before repeating the
starting procedure.
Reduce forward speed:
Reduce speed and check the slope
of the ground where you are working.
Make sure that the wheels are not
blocked and clean as needed.