Tradecraft Specialties SEMITR-22 Instruction Manual

Tradecraft Specialties SEMITR-22 Instruction Manual

Bed frame for full mattress

Advertisement

Instruction Manual
Bed Frame For Full Mattress
Model SEMITR-22
Due to the presence of small parts during assembly, keep
out of reach of children until assembly is complete.
Model SEMITR-22 Semi Truck Bed Frame
Read all instructions before assembly and use.
Keep instructions for future use.
ADULT ASSEMBLY REQUIRED
Lancaster, PA 17601
tradecraftspecialties@gmail.com
www.tradecraftspecialties.com
Revised 04/08/2018
1900 Alfa Drive
(717) 269-8934
Page
1 of 7

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SEMITR-22 and is the answer not in the manual?

Questions and answers

Summary of Contents for Tradecraft Specialties SEMITR-22

  • Page 1 Due to the presence of small parts during assembly, keep out of reach of children until assembly is complete. 1900 Alfa Drive Lancaster, PA 17601 (717) 269-8934 tradecraftspecialties@gmail.com www.tradecraftspecialties.com Page Model SEMITR-22 Semi Truck Bed Frame Revised 04/08/2018 1 of 7...
  • Page 2 ● Do not allow hanging, swinging, or leaning from or through any part of the bed or bed structure. General Specifications Assembled dimensions (approximate): 89" long, 54.5" wide, 24" high. Page Model SEMITR-22 Semi Truck Bed Frame Revised 04/08/2018 2 of 7...
  • Page 3 We use low-odor, zero VOC paint where possible and do our best to keep unpleasant odors to a minium. Disassembly To disassemble, reverse order of steps for assembly. Page Model SEMITR-22 Semi Truck Bed Frame Revised 04/08/2018 3 of 7...
  • Page 4 Parts List Page Model SEMITR-22 Semi Truck Bed Frame Revised 04/08/2018 4 of 7...
  • Page 5 Step 2 - A: Loosely fasten side assemblies [A] to rear shelf support [G] using lag bolts [E] and flat washers [F], (1) lag bolt per side with a washer on each lag bolt. Do not yet fully tighten lag bolts. Page Model SEMITR-22 Semi Truck Bed Frame Revised 04/08/2018 5 of 7...
  • Page 6 Start at rear of bed and work towards front. Leave approximately 4.5” gaps between each support bar (approximately 7” center-to- center). Page Model SEMITR-22 Semi Truck Bed Frame Revised 04/08/2018 6 of 7...
  • Page 7 If the necessary quantity of rubber thread protectors are not provided along with the hardware included with this product, please contact Tradecraft Specialties. Page...

Table of Contents