Cleaning And Maintenance; Exterior Cleaning; Interior Cleaning; Troubleshooting - EdgeStar CBR1500SG Owner's Manual

Symptoms
The beverage cooler
turns on and off
frequently.
EdgeStar Built-in Beverage Cooler

CLEANING AND MAINTENANCE

Periodic cleaning and proper maintenance will ensure efficiency, top
performance, and long life.

Exterior Cleaning

The door and cabinet may be cleaned with a mild detergent and
lukewarm water solution such as 2 tablespoons of baking soda to 1 quart
of water.
Do not use solvent based or abrasive cleaners. Use a soft sponge and
rinse with clean water. Wipe with a soft clean towel to prevent water
spotting. If the door panel is stainless steel, it can discolor when exposed
to chlorine gas and moisture. Clean stainless steel with a cloth dampened
with a mild detergent and warm water solution. Never use an abrasive or
caustic cleaning agent.

Interior Cleaning

The beverage cooler's interior should be cleaned occasionally.
1. Disconnect power to the unit.
2. Open the door and remove the contents and shelves.
3. Wait until the unit defrosts.
4. With a clean cloth, wipe down the interior of the unit.
5. Reinsert the shelves and beverages.
6. Reconnect power to the unit.

TROUBLESHOOTING

Before Calling for Help
If the unit appears to be malfunctioning, read through the OPERATION
section of this manual first. If the problem persists, check the
Troubleshooting Guide below and on the following page. The problem
could be something that can easily be solved or explained.
Possible causes
The room temperature is
higher than the
recommended ambient
environment.
The door is being opened
often.
The door is not completely
closed.
The door gasket is not
sealing properly.
The cooler does not have the
suggested ventilation.
Solutions
Run the cooler at the appropriate ambient temperature.
Minimize the number of times the door is opened.
Make sure the door is completely closed.
Make sure the door gasket is properly sealing.
Read and follow the "Installation Clearance
Requirements" section.
10