Switching Off - Sennheiser RS 120-W Instruction Manual

Using the headphone system
16 | RS 120-W
Using the headphone system
Switching on
WARNING
Danger of hearing damage due to high volume levels!
Listening at high volume levels for long periods of time
can lead to permanent hearing defects.
▷
Before putting the headphones on, adjust the volume
on the headphones to a low level (> 18).
▷
Do not continuously expose yourself to high volume
levels.
1. Connect the transmitter to the power supply system (> 12) and to
your audio source (> 11).
2. Switch your audio source on.
The ON/OFF LED lights up green. An audio signal is present and
is being transmitted.
3. Remove the headphones from the transmitter's headphone
holder.
4. Set the ON/OFF switch of the headphones to ON.
The headphones search for the paired transmitter and you hear a
melody. If the connection is successful, audio playback starts.
2. 3.
ON

Switching off

If the audio source is switched off for 5 minutes, the transmitter and
the headphones switch to standby mode. To switch off the transmit-
ter completely, disconnect the power supply unit from the wall
socket.
If the headphones have gone into standby mode and you want
to wake them up, switch the headphones off and on again.
4.
ON