Carrier AquaEdge 23XRV Controls Operation And Troubleshooting page 15

Fig. 21 — General Configuration Screen
After changing a value, press Return. The Save and Cancel icons
are displayed. Press the Save icon to save the changed value.
In the General Configuration menu the ramp loading per time can
be limited based on ^F, amps, or kW.
In addition the optional 4-20 mA Refrigerant Leak detection by
external controller can be enabled here. Alarm limits are config-
ured in the Limits Configuration menu.
Schedule Menu Screen
To access the Schedule Menu screen, press
Main Menu screen. Select Local Schedule or Schedule as applica-
ble. For Local Schedule control, select the desired time period for
the chiller to run in the LOCALOCC - Local Schedule menu
shown in Fig. 22. Go to Configure Startup Options (see Fig. 12)
and ensure that Enable Schedule Start is checked (see Fig. 13). For
Local Schedule Control press AutoStart to activate (do not press
Local On as chiller will always initiate startup when Local On is
pressed). Upon pressing AutoStart the chiller will now run as per
the configured occupancy schedule. Press the arrows at the bottom
right corner to navigate through the time periods. See Fig. 22.
There is no occupancy schedule for Network.
Fig. 22 — Local Schedule Menu Screen
Status Display Screens
Figure 23 shows the system status overview (home) screen. Press
any component on the screen to see the status of that component.
Press the arrows at the bottom right corner to navigate through the
component status displays. Figures 24-31 show the component
status displays.
Fig. 23 — System Overview (Home) Screen
Config1 on the
15
Fig. 24 — Condenser Status
Fig. 25 — Evaporator Status
Fig. 26 — HGBP Status