IBM N Series Manual page 64

Command
storage show fault
sysconfig
sysconfig
sysconfig
vif
vol options
vol options
vol status
54
IBM System Storage N series: Data ONTAP 8.0.4 7-Mode Release Notes
Change
You can now specify a
storage expansion unit
name for this command to
see information about a
specific storage expansion
unit.
When the -r option is used
to display disk information
for SAS-connected disks,
the CHAN (channel)
column now displays the
port as "A" or "B", just as it
does for FC-connected
disks. Previously, "1" and
"2" were used.
When the -a option is used,
the output includes status
and power information for
any IOXM modules present.
When the -v option is used,
any disabled ports show
"N/A" for the data link
rate.
This command has been
replaced by the ifgrp
command.
The extent option enables
extents but can only be
used on FlexVol volumes.
The read_realloc option
enables read reallocation
but can only be used on
FlexVol volumes.
When the -r option is used
to display disk information
for SAS-connected disks,
the CHAN (channel)
column now displays the
port as A or B, just as it
does for FC-connected
disks. Previously, 1 and 2
were used.
Documentation
na_storage(1) man
page
na_sysconfig(1) man
page
na_sysconfig(1) man
page
na_sysconfig(1) man
page
Data ONTAP 8.0
7-Mode Network
Management Guide
na_vol(1) man page
and the Data ONTAP
8.0 7-Mode System
Administration Guide
na_vol(1) man page
na_vol(1) man page
Release
command
changed in
8.0.1
8.0
8.0.1
8.0.2
8.0
8.0
8.0
8.0