Hatco LW-2 Installation & Operation Manual
Hatco LW-2 Installation & Operation Manual

Hatco LW-2 Installation & Operation Manual

Portable lamp warmer lw series
Hide thumbs Also See for LW-2:

Advertisement

Quick Links

PORTABLE LAMP WARMER
This
manual
contains
information concerning the maintenance, use
and operation of this product. Failure to follow
the instructions contained in this manual may
result in serious injury. If you're unable to
understand the contents of this manual, please
bring it to the attention of your supervisor. Do
not operate this equipment unless you have
read and understood the contents of this
manual.
LW Series
Installation &
Operating Manual
I & W #07.05.082.00
important
safety
Este manual contiene importante información
sobre seguridad concerniente al mantenimiento,
uso y operación de este producto. Cualquier falla
en
el
seguimiento
contenidas en este manual puede resultar en un
serio daño. Si usted no puede entender el
contenido de este manual por favor pregunte a
su supervisor. No opere este equipo al menos
que haya leído y comprendido el contenido de
este manual.
de
las
instrucciones

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LW-2 and is the answer not in the manual?

Questions and answers

Summary of Contents for Hatco LW-2

  • Page 1 PORTABLE LAMP WARMER This manual contains information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you’re unable to understand the contents of this manual, please bring it to the attention of your supervisor.
  • Page 2: Table Of Contents

    The LW-2 model incorporates a specially designed stand that keeps food holding pans above the countertop, providing an effective insulation to prolong serving times. The base of the LW-2 holds full-size and half-size Gastronorm pans of appetizers, chicken wings or other hot foods.
  • Page 3: Important Safety Instructions

    Some aftermarket or generic replacement parts do not have the characteristics that will allow them to operate safely in Hatco equipment. It is essential to use Hatco Replacement Parts when repairing Hatco equipment. Failure to...
  • Page 4: Model Description

    6' (1829 mm) cord and plug with an in-line On/Off switch, located outside of the heat zone. The LW-2 comes standard with two 250 watt white bulbs. Coated bulbs are available through the factory.
  • Page 5: Specifications

    (318 mm) (559 mm) (610-749 mm) LW-3 32-5/8" 12-1/4" 25-1/2" (829 mm) (311 mm) (648mm) NEMA 5-15P Figure 3. Plug Configuration Height (241-394 mm) 16" (406 mm) Figure 4. Dimensions–LW-2 Figure 5. Dimensions–LW-3 SPECIFICATIONS CEE 7/7 Schuko BS 1363 Form No. LWM-1104...
  • Page 6: Electrical Rating Chart

    230-240 (CE) LW-3 220-230 (CE) 230-240 (CE) INSTALLATION UNPACKING The Hatco Portable Lamp Warmers are shipped with most components installed and ready for operation. The following installation instructions must be performed before plugging in and operating. 1. Remove unit from box.
  • Page 7: Placing Into Service

    Use caution when touching these areas to avoid injury. WARNING To prevent any injury, discontinue use if power cord is frayed or worn. CAUTION Damage to countertop material caused by heat generated from Hatco equipment is not covered under Hatco Warranty. manufacturer base application information.
  • Page 8: Maintenance

    DO NOT submerge in water. Do not operate if it has been submerged in water. To preserve the finish of the Hatco Portable Lamp Warmer, it is recommended that the surfaces be wiped daily with a damp cloth. Stubborn stains may be removed with a good non-abrasive cleaner.
  • Page 9: Hatco Limited Warranty

    Hatco reserves the right to accept or reject any such claim in whole or in part. Hatco will not accept the return of any Product without prior written approval from Hatco, and all such approved returns shall be made at Buyer’s sole expense.
  • Page 10 NOTES Form No. LWM-1104...
  • Page 11 NOTES Form No. LWM-1104...
  • Page 12: Authorized Parts Distributors

    Cone’s Repair Service Flanders Moline 309-797-5323 P.O. Box 340500, Milwaukee, WI 53234-0500 U.S.A. Parts & Service Fax (800) 690-2966 Printed in U.S.A. November 2004 HATCO AUTHORIZED PARTS DISTRIBUTORS NEW YORK Acme American Repairs, Inc. 317-545-9655 Brooklyn Alpro Service Co. Brooklyn...

This manual is also suitable for:

Lw-3

Table of Contents