Warnings - Cisco Router 831 Hardware Installation Manual

Preparing for Installation

Warnings

Warning
Warning
Warning
Warning
Warning
Warning
Warning
Cisco 831 Router and SOHO 91 Router Hardware Installation Guide
2-2
Before installing the router, read the following warnings:
Read the installation instructions before you connect the system to its power
source.
Only trained and qualified personnel should be allowed to install, replace, or
service this equipment.
No operator serviceable parts inside. Refer servicing to qualified personnel.
Before working on a chassis or working near power supplies, unplug the power
cord on AC units; disconnect the power at the circuit breaker on DC units.
This equipment is intended to be grounded. Ensure that the host is connected to
earth ground during normal use.
This product relies on the building's installation for short-circuit (overcurrent)
protection. Ensure that a fuse or circuit breaker no larger than 120 VAC, 15A U.S.
(240 VAC, 10A international) is used on the phase conductors (all
current-carrying conductors).
Before working on equipment that is connected to power lines, remove jewelry
(including rings, necklaces, and watches). Metal objects will heat up when
connected to power and ground and can cause serious burns or weld the metal
object to the terminals.
Chapter 2 Installation
78-14784-02