Page 1
• ! Check unit before Toll Free: 1.800.294.4667 Hoops Incorporated each use for loose Web: www.hoopsincorporated.com 22047 Lutheran Church Rd. hardware, excessive FAX: (281) 357-4822...
1. Prior to goal assembly, call utility services for location of underground utility lines before you dig. 2. NOTE: Immediately unpack all components and cross check against bill of materials. Report any shortages to Hoops Inc. customer service at 1.800.294.4667. 3. Assembly is a two part process.
Page 4
ANCHOR SYSTEM INSTALLATION INSTRUCTIONS (Day 1) 1. Choose the proper location to dig for the concrete footing. Use the distance chart in figure C to help you make your decision. When choosing the exact position to dig, make sure to maximize the amount of playing surface while minimizing possible driveway obstruction.
Page 5
NOTE: It is better to mix it slightly wet than too dry. 6. Insert the broomstick in 3 or 4 different places and vibrate up and down to settle the concrete. Submerge the four Anchor Footing Rebar (M) pieces into the center of the hole spaced evenly. Next set the anchor system into the wet concrete, vibrate it as it goes in to make sure the concrete fills in around the 16mm Anchor J-Bolts (K) hooks.
Page 6
PRO DUNK® ASSEMBLY INSTRUCTIONS (~Day 5) 7. Loosen the top four 16mm J-Bolt Hex Nuts (L) from the 16mm Anchor J- Bolts (K). Leave Anchor Footing Template (N) in place. 8. Put the 16mm Anchor J-bolt Washers (Z) on each Anchor J-Bolt (K). 9.
Page 7
the rim hole pattern in the H-Frame Backboard Mount (D) lines up with the rim hole pattern in the backboard, adjust as needed. When you are satisfied with alignment, attach backboard to H-Frame Backboard Mount (D) at all points along the top and bottom of the board using the 10mm X 3cm Hex Bolts (R), 10mm Flatwashers (S), 10mm Lockwashers (T) and 10mm Hex Nuts (U) as shown in figure D.
Page 8
22. If you’d like to restrict height adjustment from 10’ to 7’ you can optionally insert the Black Safety Rod And Pin (AA) into the tube on the back of the Vertical Post (A). NOTE: It is advisable to do so to avoid injury...
Page 11
Pro Dunk® Care Information BACKBOARD Items needed to clean backboard: • 100% cotton soft cloth, (only) • Mild dish washing liquid for soap • Luke warm water Cleaning Directions Rinse backboard with lukewarm water. Wash gently with a 100% Cotton soft cloth, lukewarm water and mild soap.
Page 12
Hoops Inc.. Liability Hoops Inc. shall not be liable for indirect, special, or consequential damages arising out of or in connection with the use or performance of the products or other damages with respect to any economical loss, loss of property, loss of enjoyment of use, costs of removal, installation or other consequential damages for breach of any expressed or implied warranty on these products.
Need help?
Do you have a question about the Pro Dunk Platinum and is the answer not in the manual?
Questions and answers