Table of Contents
Advertisement
Troubleshooting
EN
EN
Troubleshooting
Therefore check the product using this section. In most cases the problem can
be solved quickly.
WARNING! Only perform the steps described within these instructions!
All further inspection, maintenance and repair work must be performed
cannot solve the problem yourself!
Problem
1.
Product
does not
start
2.
Product
does not
reach full
power
3.
Unsatisfac-
tory result
4.
Product sud-
denly stops
5.
Excessive
vibration or
noise
30
MNL_18V IMPACT DRIVER_MID18-LI_IMGB_V1_211224.indd 30
Possible cause
1.1. Forward / reverse rota-
tion control at centre lock
position
1.2. Battery pack not properly
attached
1.3. Battery pack discharged 1.3. Remove and charge bat-
1.4. Battery pack damaged
1.5. Other electrical defect to
the product
2.1. Battery pack capacity too
low
2.2. Air vents are blocked
2.3. Ambient temperature is
cold
3.1. Drill bit is worn
3.2. Drill bit not suitable for
intended operation
4.1. Product overloaded
4.2. Battery pack discharged 4.2. Remove and charge bat-
4.3. Battery too hot
5.1 Drill bit is dull / damaged
Solution
1.1. Push forward / reverse
rotation control to left or
right
1.2. Attach properly
tery pack
1.4. Replace with a new one
of the same type
1.5. Check by a specialist
electrician
2.1. Charge battery pack
2.2. Clean the air vents
2.3. Run the product for a
while to warm up.
3.1. Replace with a new one
3.2. Use suitable drill bit
4.1. Remove the product
from the workpiece and
switch it on again
tery pack
4.3. Remove battery pack
and let it cool down
5.1 Replace with a new one
TTI885IPD
2021/12/23 10:31 PM
Advertisement
Table of Contents
