Toro Multi-Pro 5800 Installation Instructions Manual page 9

4
Installing the Eductor
Parts needed for this procedure:
1 Eductor
1 Handle
2 Flange-head bolt
1 Spring clamp
2 Bolt (#10-24 x 1/2 inch)
2 Locknut (#10-24)
4 Bolt (3/8 x 1 inch)
4 Locknut (3/8 inch)
2 Flange-head nut
3 Hex-head bolt
1 Latch post
1 Latch handle
1 T-valve
1 Gasket
1 Worm-screw clamp
Procedure
1. Attach the latch post to the eductor handle using a
hex-head bolt (Figure 13).
1. Handle
2. Eductor
3. Flange-head nut
4. Spring clamp
5. Bolt (#10-24 x 1/2 inch)
2. Attach the extension bracket to the main support frame
using 2 hex-head bolts
3. Connect the latch handle to the extension bracket
(Figure 13).
4. Attach the handle to the eductor using 2 flange-head
bolts and flange-head nuts
5. Lower the cradle into the down position.
6. Align the holes in the eductor assembly mount plate
with the slotted holes in the back plate of the cradle
assembly (Figure
Note: The fasteners need to be loose enough so that
they can travel in the slot when the eductor is initially
raised up into the transport position. This allows for
further adjustment.
9
Figure 13
6. Flange-head bolt
7. Locknut (#10-24)
8. Latch post
9. Extension bracket
10. Latch handle
(Figure 13).
(Figure 13).
14).