Toro Multi-Pro 5800 Installation Instructions Manual page 4

Procedure
5
6
Note: Determine the left and right sides of the machine from the normal operating position.
1
Installing the Eductor Valve
and Hoses
Parts needed for this procedure:
1 Eductor valve assembly
2 Flange nut (1/4 inch)
1 Fitting (1 inch)
1 Retainer pins
Eductor valve bracket (The bracket may already be
1
installed from a previous kit installation)
1 Relief hose (10 3/4 inches)
1
Supply hose (18 1/2 inches)
1 Bypass hose (12 inches)
Procedure
1. Move to the rear of the machine and locate the boom
valve assembly on the boom valve mount bracket.
2. Remove and discard the 3 hoses shown in
keep the retainer pins.
Description
Bulkhead
O-ring
Locking ring
Retaining fork
Forward hose assembly
Gasket
Worm-screw clamp
R-clamp
Carriage bolt (5/16 x 1 inch)
Lock nut (5/16 inch)
Supply hose
Gasket
Worm-screw clamp
Hose clamp
Hose adapter
Retainer pin
Figure 3
Qty.
1
1
1
2
1
1
1
1
1
1
1
1
1
1
1
1
1. Remove and discard
3. Secure the eductor valve bracket to the boom valve
assembly using the bolts and nuts that secure the
but
pressure filter to the boom valve bracket; refer to Box
A of Figure
4
Use
Install the forward hose.
Install the supply hose.
Figure 3
4.