Toro Multi-Pro 5800 Installation Instructions Manual page 12

4. Install a lock nut over the bolt in the R-clamp and
finger tighten at this time
Note: This will allow for later adjustment.
5. Attach the other end of the hose to the forward-facing
opening of the eductor using a gasket and worm-screw
clamp (Figure 20).
Figure 20
1. Worm-screw clamp
2. Hose
6. Raise and lower the eductor to ensure that the hose
does not catch on anything.
Figure 21
1. Eductor hose
2. Tank
(Figure 19).
3. O-ring
4. Eductor
3. Slack in the hose
6
Installing the Supply Hose
Parts needed for this procedure:
1 Supply hose
1 Gasket
1 Worm-screw clamp
1 Hose clamp
1 Hose adapter
1 Retainer pin
Procedure
1. Secure the end of the supply hose without a bulkhead
to the rear opening on the eductor valve using a gasket
and worm-screw clamp
1. Eductor
2. O-ring
2. Route the open end of the supply hose rearward past
the pump and turn back toward the valve assembly
under the relief valve.
3. Staying under the agitation hose but above the left side
mount for the center boom, route the hose upward to
the eductor valve assembly.
4. Slide a loosened hose clamp over the open end of the
hose (Figure 23).
12
(Figure 22).
Figure 22
3. Hose
4. Worm-screw clamp