Toro Multi-Pro 5800 Installation Instructions Manual page 8

3
Installing the Latching
Components
Parts needed for this procedure:
2 Spring
Installing the Springs
1. Install the spring in the hole in the lower end of the
angled tab on the side of the frame assembly
10).
1
G013931
Figure 10
1. Angled tab
2. Hole in tab
3. Spring
2. Hook one end of the spring into the hole and the other
end onto the spring post
3. Make sure that the spring end is seated properly in the
groove in the post
4. Repeat steps 1 through
5. Tighten the 2 set screws in the left arm.
Adjusting the Tongue Position
Move the cradle assembly into the upper Transport position
to adjust the tongue.
1. Lift up on the handles to raise the assembly while
slightly tipping it toward the tank.
2. Guide the tongue under the crossbar with the welded
tab in the upper portion of the frame assembly.
3. Let the assembly pivot down, toward the tank.
4. Making sure that the plastic stops are in contact with
the spring tabs, apply enough pressure against the back
2
3
4
5
4. Post
5. Groove
(Figure 10).
(Figure 10).
3 for the other side.
plate assembly of the cradle to compress the spring
tabs midway
(Figure
1. Spring tab under pressure
2. Back plate
5. While maintaining the pressure on the back plate, slide
the tongue toward you until the lip of the tongue plate
contacts the crossbar
1. Tongue-plate lip
2. Fasteners
6. Tighten the fasteners in the tongue to secure its
position, then release pressure on the back plate.
Note: Check to see if there is any play in the cradle.
It should be held snug to the frame assembly. You can
repeat this procedure once the eductor is installed to
adjust the locked position.
8
(Figure 11).
Figure 11
3. Spring tab
(Figure 12).
Figure 12
3. Slot in plate
4. Welded tab