Toro Multi-Pro 5800 Installation Instructions Manual page 10

Figure 14
1. Bolt (3/8 x 1 inch)
2. Back plate
3. Locknut (3/8 inch)
7. Install 4 bolts (3/8 x 1 inch) and locknuts (3/8 inch) to
mount the eductor.
Note: Do not tighten the bolts at this time.
8. To carefully raise the eductor in the cradle assembly up
to the transport position, do the following:
A. Lift the lower handle to raise the eductor while
slightly tipping it toward the tank.
B. Guide the tongue under the crossbar with the
welded tab in the upper portion of the frame
assembly.
C. Then pivot the assembly toward the tank, taking
care to line up the spring clamp with the large
pivot housing in the lower portion of the frame.
D. Push until the clamp snaps over the pivot housing
as shown in Figure
Figure 15
1. Spring clamp
9. Check the eductor height on the cradle back plate and
adjust it as necessary.
4. Eductor assembly mount
hole
5. Eductor assembly mount
15.
2. Pivot housing
10. Tighten the fasteners securing the eductor to the cradle.
Note: Torque the fasteners to 36-45 N-m (27-33 ft-lb).
11. Tighten the 2 set screws on the left pivot arm.
12. Check the overall position of the eductor assembly on
the tank strap.
Note: The eductor should be upright, in the transport
position. Loosen the lower locknut on the frame
assembly securing it to the tank. Do not remove the
locknut. Adjust the position as necessary and tighten
the locknut. Make sure that the strap is secure to the
tank.
13. Connect the T-valve to the eductor assembly using a
gasket and a worm-screw clamp
1. T-valve
10
(Figure 16).
Figure 16
2. Gasket and worm-screw
clamp