Toro Multi-Pro 5800 Installation Instructions Manual page 7

Figure 8
1. Back plate assembly
2. Hair pin
3. Flat washer
4. Bushing
5. Pivot pin
6. Jam nut (3/8 inch)
A. Start by installing the right cradle arm to the
frame. The right cradle arm is denoted by have
the long axle.
B. Insert the axle through the hinge shaft.
C. Loosely mate the left arm to the exposed axle on
the other side of the frame.
D. Install a bushing into the outside hinge holes of
the back plate assembly.
E. Move the back plate assembly into position
between the upper holes in each arm.
F. Install a pivot pin through the upper hole in the
arm and the hinge hole with the bushing in the
back plate assembly.
G. Install the handles to the lower holes in the arms.
Secure with a bolt (3/8 x 1-1/4 inches) and jam
nut (3/8 inch).
H. Repeat for the opposing arm.
I. Install a set screw to the left arm at the lower
hinge point (Figure
to allow for adjustment of the cradle system.
7. Handle
8. Bolt (3/8 x 1–1/4 inches)
9. Right cradle arm
10. Main support frame
assembly
11. Cradle arm axle
12. Pivot housing
9). Do not tighten at this time
1. Cradle arm, left
2. Pivot housing
7
Figure 9
3. Set screw
4. Holes in the cradle arm