Beko BHCA63741BHSI User Manual page 17

5
Installation of appliance
• The bolts and dowels provided are suitable for
brick walls. For other construction material (e.g.
drywall, plate, porous concrete), suitable fixing
dowels and nuts shall be used.
(Figure 7)
CAUTION: Before drilling, ensure
A
that there are no power, gas or wa-
ter pipes in the close proximity of the
drilling locations.
Draw a mid location line from the ceiling perpendi-
cular to the lower edge of the hood.
Paste the installing template provided within the
accessories on the surface where the hood is to
be mounted. In doing this operation, observe the
mounting height of the hood (Figure 6).
There is a tab in the middle of the flue connec-
tion plate. Place the middle point of this tab on
the line that is drawn perpendicular to the wall. In
doing this operation, adjust the hood according to
the maximum height (Figure 1). Mark the holes
where the flue connection plate will be mounted
with the help of a pen (Figure 7/a).
Drill the marked points with Ø6mm drill and in-
sert 2 plastic dowels in the drilled holes (Figure
7/a). Fix the flue connection plate to the wall with
3,9x22 screws (Figure 7/a).
Cooker Hood / User Manual
To assemble the hood body, you can use the A,
B, C, D Ø10 mm drill on the assembly template,
and insert Ø10 mm plastic dowels at these points.
(Figure 7/b).
2 piece 5.5x60 suspension screw with a clearance
of 5 mm between the screw head and the wall
(Figure 7/b).
(Figure 8)
Ø10mm
1. Hanger plate
Ø5,5x60
2. Hanging plate connection screw
In order to install your hood to the wall, loosen the
screws on the hanger plates mounted on the mo-
tor cabin and pull them up, and then fasten again
(Figure 8/A).
Turn on the suction glass of the hood and remove
the aluminum oil filter (Figure 4).
Ø4,8x50mm
(Figure 9)
Hold the cooker hood by its body and place it on
the mounting screws on the wall and tighten the
screws (Figure 9).
Secure the cooker hood with two 5.5x60 screws to
the wall through the mounting hole on the interior
of the appliance (Figure 9).
17 / EN