Spin Drying - Whirlpool LFP580GR Technical & Service Manual

TROUBLE
Drain takes time too
long.
Note: In draining, the water level sensor can Note: In draining, the water lever sensor can
not reset in 8minutes. not reset in 8minutes.
The number window LED display Four of the course lamp (NORMAL、
abnormal code:
DELICATE、BLANKET、
ECO-SPEEDY) begin blinking on and on and off at the same time and the
electric buzzer sounds to indicate a off at the same time and the electric
problem. buzzer sounds to indicate a problem.
• If the Drain Hose is too long or high, it may
make draining impossible.
• The extend Drain Hose to a maximum long of
3 meters and maximum high of 10
centimeters.
e. Spin Drying
Spin drying cycle
does not work.
Note:
1. The safety switch works 3 times
continuously. Four of the course lamp
(NORMAL 、 HEAVY
BLANKET 、 ECO-SPEEDY) begin
blinking on and off at the same time
and the electric buzzer sounds to
indicate a problem.
2. Do not disconnect the wire from the
capacitor, because
de-pressing noise from outside to the
micro-computer.
INSPECTION INSPECTION INSPECTION
and begin blinking
Yes
Does safety
device work?
No
DUTY 、
this wire acts as
CAUSES
Valve bellows is deformed.
'
Drain hose ass y is
deformed.
Hose is connected in the
wrong way.
Hose is too long or position of
hose is too high.
Machine inclines.
The V-belt is slipping.
The V-belt is snapped.
Small pulley mounting
screw is loosed.
Motor is disconnected or
burnt.
Capacitor is broken or
disconnected.
'
Bearing ass y is defective.
Torque motor is defective.
Brake lever is defective.
Thermostat on motor is
opened.
Poor contact of 6-pin
connectors (blue &white).
Control circuit board is
defective.
6
LFP580GR
REMEDY
Replace.
Repair or replace.
Repair.
Repair.
Replace with lever.
Adjust the motor
position.
Replace.
Tighten up.
Replace.
Replace.
Replace.
Replace.
Repair or replace.
Repair or replace
after cooling down.
Repair or replace.
Replace.