Spin Drying - Whirlpool WWA-680 Service Manual

TROUBLE INSPECTION INSPECTION INSPECTION
Drain takes time too
long.
Note: In draining, the water level sensor can Note: In draining, the water lever sensor can
not reset in 8minutes. not reset in 8minutes.
The number window LED display The number window LED display
abnormal code: abnormal code:
on and off at the same time and the on and off at the same time and the
electric buzzer sounds to indicate a electric buzzer sounds to indicate a
problem. problem.
• If the Drain Hose is too long or high, it may
make draining impossible.
• The extend Drain Hose to a maximum long of
3 meters and maximum high of 10
centimeters.
e. Spin Drying
Spin drying cycle
Does safety
does not work.
device work?
Note:
1. The safety switch works 3 times
continuously. The number window
LED display abnormal code:
begin blinking on and off at the same
time and the electric buzzer sounds to
indicate a problem.
2. Do not disconnect the wire from the
capacitor, because this wire acts as
de-pressing noise from outside to the
micro-computer.
Valve bellow is deformed.
Drain hose ass
Hose is connected in the
wrong way.
Hose is too long or position of
and begin blinking and begin blinking
hose is too high.
Yes
Machine inclines.
No
The V-belt is slipping.
The V-belt is snapped.
Small pulley mounting
and
screw is loosed.
Motor is disconnected or
burnt.
Capacitor is broken or
disconnected.
Bearing ass
Torque motor is defective.
Brake lever is defective.
Thermostat on motor is
opened.
Poor contact of 6(4)-pin
connectors (blue &white).
Control circuit board is
defective.
CAUSES
Replace.
'
y is deformed.
Repair or replace.
Repair.
Repair.
Replace with level.
Adjust the motor
position.
Replace.
Tighten up.
Replace.
Replace.
'
y is defective. Replace.
Replace.
Repair or replace.
Repair or replace
after cooling down.
Repair or replace.
Replace.
6
REMEDY
WWA-680