Rs485 Configuration - iSMA CONTROLLI iSMA-B-MG-IP User Manual

iSMA-B-MG-IP User Manual
This page allows to set parameters such as:
• Baud Rate: read/write, the M-Bus bus baud rate from 300 up to 38400;
• M-Bus Timeout: read/write, the timeout for M-Bus messages;
• Received Frames: read-only, the number of received frames;
• Transmitted Frames: read-only, the number of transmitted frames;
• Alarms: read-only, the number of M-Bus alarms.
WARNING! To save changes, please use the Submit button.

7.4 RS485 Configuration

This page allows to enter configuration parameters and show information of the device's
COM1 port.
This page allows to set parameters such as:
• Baud rate: read-only, the RS485 baud rate from 2400 up to 115200;
• Modbus Config: read-only, the Modbus protocol type–RTU or ASCII;
• Stop Bits: read/write, the number of stop bits (1 or 2);
Figure 18. M-Bus configuration page
Figure 19. RS485 configuration page
www.ismacontrolli.com DMP260en | 1st Issue rev. 6 | 05/2022 page 25 of 29