Hatco GR3SDH-27 Installation And Operating Manual

Hatco GR3SDH-27 Installation And Operating Manual

Glo-ray™ heated glass merchandisers gr3sdh & gr3sds series
Hide thumbs Also See for GR3SDH-27:

Advertisement

Heated Glass Merchandisers
GR3SDH & GR3SDS Series
This manual contains important safety information
concerning the maintenance, use and operation of this
product. Failure to follow the instructions contained in this
manual may result in serious injury. If you're unable to
understand the contents of this manual, please bring it to
the attention of your supervisor. Do not operate this
equipment unless you have read and understood the
contents of this manual.
GLO-RAY
Installation &
Operating Manual
I&W #07.05.146.00
Este manual contiene importante información sobre
seguridad concerniente al mantenimiento, uso y
operación de este producto. Cualquier falla en el
seguimiento de las instrucciones contenidas en este
manual puede resultar en un serio daño. Si usted no
puede entender el contenido de este manual por
favor pregunte a su supervisor. No opere este
equipo al menos que haya leído y comprendido el
contenido de este manual.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GR3SDH-27 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Hatco GR3SDH-27

  • Page 1 Heated Glass Merchandisers GR3SDH & GR3SDS Series Operating Manual This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you’re unable to understand the contents of this manual, please bring it to the attention of your supervisor.
  • Page 2: Table Of Contents

    (identification decal located on the rear of the unit), voltage and purchase date of your Glo-Ray Glass Merchandiser in the spaces below. Please have this information available when calling Hatco for service assistance. Model No. ________________________________ Serial No. ________________________________...
  • Page 3: Important Safety Information

    Some aftermarket or generic replacement parts do not have the characteristics that will allow them to operate safely in Hatco equipment. It is essential to use Hatco Replacement Parts when repairing Hatco equipment. Failure to...
  • Page 4 IMPORTANT SAFETY INFORMATION IMPORTANT! Read the following important safety instructions to avoid personal injury or death, and to avoid damage to the equipment or property. CAUTIONS Some exterior surfaces on the unit will get hot. Use caution when touching these areas to avoid injury.
  • Page 5: Model Descriptions

    MODEL DESCRIPTION ALL GR3SD MODELS All GR3SD Models feature a thermostatically controlled hardcoated heated base and glass dual heat source which conducts heat upward to keep the food on the glass shelf warm, and radiates heat downward to blanket the product below. Units also include tempered glass side panels, product divider rods, fluorescent display lights, and a cord and plug set.
  • Page 6: Electrical Rating Charts

    SPECIFICATIONS ELECTRICAL RATING CHART – GR3SDH MODELS - HORIZONTAL MODELS - SINGLE SHELF Model Voltage GR3SDH-27 GR3SDH-33 GR3SDH-39 † NEMA 5-20P for Canada ELECTRICAL RATING CHART – GR3SDH MODELS - HORIZONTAL MODELS - DUAL SHELF Model Voltage GR3SDH-27D GR3SDH-33D 120/208...
  • Page 7: Dimensions Gr3Sdh Models

    DIMENSIONS - GR3SDH MODELS GR3SDH MODELS - SINGLE HORIZONTAL SHELF Width Depth Model GR3SDH-27 27-1/4" 27-1/4" (692 mm) (692 mm) GR3SDH-33 33-1/4" 27-1/4" (845 mm) (692 mm) GR3SDH-39 39-1/4" 27-1/4" (997 mm) (692 mm) Height includes 2-1/2" (64 mm) legs attached.
  • Page 8: Dimensions Gr3Sds Models

    SPECIFICATIONS DIMENSIONS - GR3SDS MODELS GR3SDS MODELS - SINGLE SLANTED SHELF Width Depth Model GR3SDS-27 27-1/4" 26-7/8" (692 mm) (683 mm) (521 mm) GR3SDS-33 33-1/4" 26-7/8" (845 mm) (683 mm) (521 mm) GR3SDS-39 39-1/4" 26-7/8" (997 mm) (683 mm) (521 mm) Height includes 2-1/2"...
  • Page 9: Installation

    ALL MODELS Glo-Ray ® Heated Glass Merchandisers are shipped with most components pre-assembled. Care should be taken when unpacking shipping carton to avoid damage to unit and components enclosed. WARNING To prevent any injury or damage to the unit do not pull unit by power cord.
  • Page 10: Location

    INSTALLATION LOCATION NOTE: Unit must be transported in the upright position. For proper operation and maximum performance, locate the Heated Glass Merchandisers in an area where the ambient air temperature is constant and is a minimum of 70°F (21°C). Areas which are susceptible to active air movements or currents should be avoided, i.e., near exhaust fans or hoods and air conditioning ducts.
  • Page 11: Operation

    WARNING To avoid any injury, do not allow liquids to spill onto the heated glass shelf. WARNING Unit is not waterproof. To avoid electrical shock or personal injury DO NOT submerge in water. Do not operate if it has been submerged in water.
  • Page 12: Maintenance

    Some aftermarket or generic replacement characteristics that will allow them to operate safely in Hatco equipment. It is essential to use Hatco Replacement Parts when repairing Hatco equipment. Failure to use Hatco Replacement Parts may subject operators of the equipment to hazardous electrical voltage, resulting in electrical shock or burn.
  • Page 13: Accessories

    DISPLAY SIGN HOLDER A display sign holder (sign not included) is available for installation on top or intermediate shelf, customer side. To install follow these steps and see Figure 9. 1. Remove protective paper from acrylic surfaces. 2. Remove front divider. 3.
  • Page 14 ACCESSORIES FLIP-UP DOORS Flip-up doors are available for installation on the front or back side for units susceptible to active air movements or air currents caused by exhaust fans, hoods or air conditioning ducts. 1. Remove protective paper from acrylic surfaces. 2.
  • Page 15: Hatco Limited Warranty

    Hatco reserves the right to accept or reject any such claim in whole or in part. Hatco will not accept the return of any Product without prior written approval from Hatco, and all such approved returns shall be made at Buyer’s sole expense.
  • Page 16: Authorized Parts Distributors

    Jay Hill Repair Fairfield Service Plus Flanders P.O. Box 340500, Milwaukee, WI 53234-0500 U.S.A. Parts & Service Fax (800) 690-2966 Printed in U.S.A. June 2006 HATCO AUTHORIZED PARTS DISTRIBUTORS NEW YORK Acme American Repairs, Inc. 317-545-9655 Brooklyn Alpro Service Co. Brooklyn...

Table of Contents