Pioneer CDX-MG6056ZH Service Manual page 88

CX-890
7. Loosen the 2 screws (D). Remove the Gear cover.
8. Loosen the 3 screws (E). Remove the Motor bracket
assy.
9. Remove the 5 polyslider washers, then gears and
shaft.
10. Loosen the 4 screws. Remove the Cam gear motor
and ELV motor.
- How to remove the Loading motor
1. Insert a short pin into the flexible PCB of the Pickup
unit.(See Fig. 30)
Remove the Cover from the Servo unit. (See Fig. 30)
Disconnect the flexible PCBs from the connectors
CN101 and CN301. (See Fig. 30)
Disconnect the the flexible PCB (Motor PCB (A)) from
the connector CN201 on the Servo unit. (See Fig. 36)
2. Unhook the spring. Remove the Door open lever.
3. Loosen the 3 screws. Remove the PCB units (C) & (D)
and the frame.
4. Remove the spring (A).
24
Motor bracket
assy
Cam gear motor
ELV
motor
Shaft
White
Black
PCB (D)
Frame
Front
Gear cover
Fig. 37
Apply grease (White:EM-
50L) to the Shaft and
gears.
Spring
Door open lever
Black
PCB (C)
Fig. 38
Fig. 39