Dell PowerEdge 1800 Installation And Troubleshooting Manual page 99

Figure 7-3. Installing a 5.25-Inch Drive
externally accessible drive bay
5.25-inch drive
8
Connect a DC power cable connector to the drive's power input connector. See Figure 7-3.
9
If you are connecting the drive to a controller card, proceed to step 10. If you are connecting
the interface cable to a system board connector:
Remove the baffle/back fan assembly. See "Removing the Baffle/Back Fan Assembly."
a
Press and hold the expansion-card guide release tab and remove the expansion-card
b
guide. See Figure 6-1.
Remove the four drive bay screws and slide the drive bay forward to access the drive-cable
c
retainer.
screws (2)
power cable
interface cable
Installing Drives
99