Dell PowerEdge 1800 Installation And Troubleshooting Manual page 108

9
Install the hard-drive cage:
With the side of the drive cage labeled "Top" facing toward the external drive bays, slide
a
the drive cage into the system. See Figure 7-8.
Replace the four screws that secure the drive cage in the system.
b
10
Connect a DC power cable connector to the drive's power input connector.
11
Connect an interface cable connector to the drive's interface connector:
• If you are installing one or two SATA hard drives and using the integrated SATA
controller(s), connect the interface cable(s) between the drive(s) and the system board
SATA connectors. See Figure 7-9.
NOTE:
connectors are labeled "0" and "1." Ensure that you match the connector numbers with the drive bay
numbers and the appropriate SATA connector on the system board.
• If you are installing up to six SATA hard drives and using an optional SATA controller
card, connect the interface cables to the drives and the controller card. See Figure 7-10.
NOTE:
through "5." Ensure that you match the connector numbers with the drive bay numbers and the
appropriate SATA connector on the controller card.
For information about configuring the SATA controller, see the documentation that came
with the SATA controller.
108
Installing Drives
The drive bays are labeled "0" through "5" and the two-connector SATA interface-cable
The drive bays and the six-connector SATA interface-cable connectors are labeled "0"