Dell PowerEdge 1800 Installation And Troubleshooting Manual page 100
Hide thumbs
Also See for PowerEdge 1800:
- Hardware installation manual (112 pages) ,
- Information update (66 pages) ,
- Supplementary manual (20 pages)
Table of Contents
Advertisement
NOTICE:
overheat.
Slide the interface cable into the drive-cable retainer.
d
Replace the hard-drive bay and screws.
e
Replace the expansion-card guide.
f
Replace the baffle/back fan assembly. See "Installing the Baffle/Back Fan Assembly."
g
Figure 7-4. Accessing the System Board Drive Connectors
interface cable
drive bay
10
Connect the interface cable to the drive and to the system board or controller card.
•
Figure 7-5 illustrates a common cable configuration for externally accessible IDE drives.
•
Figure 7-6 illustrates a SCSI half-height tape drive connected to the SCSI controller on
the system board.
•
Figure 7-7 shows a SCSI half-height tape drive connected to a SCSI controller card.
For information about the controller card, see the documentation that accompanied the
card.
100
Installing Drives
Cables not installed into the drive-cable retainer may block air flow and cause the system to
drive-cable
retainer
Advertisement
Table of Contents
Troubleshooting
