Operation - Hatco FLAV-R-FRESH FDW-1 Installation & Operating Manual

OPERATION

1. Plug the cabinet into a properly grounded electrical
outlet of the correct voltage, size and plug
configuration. See ELECTRICAL
SPECIFICATIONS for details.
2. Place the power switch in the "on" position.
The humidity cycle and low water indicators will
light up at this time. See Figure 7.
CAUTION
Water Quality Requirements – Incoming water
in excess of 3.0 grains of hardness per gallon (GPG)
(.75 grains of hardness per liter) must be treated
and softened before being used. Water containing
over 3.0 GPG (.75 GPL) will decrease the efficiency
and reduce the operating life of the unit.
NOTE: Product failure caused by liming or sediment
buildup is not covered under warranty.
3. Fill the water reservoir with softened or distilled
water. To fill the reservoir, lift up the fill cup cover
and pull forward. See Figure 7. Slowly pour
the water into the cup until the red light for low
water indication goes off.
WARNING
Overfilling can cause electrical shock. Stop filling
when low-water light goes off.
Use of softened or distilled water is recommended
to preserve the life of the electrical and mechanical
components in the reservoir. Do not use deionized
water. If "hard" water is used, the reservoir will
require periodic cleaning and deliming. See
MAINTENANCE for deliming instructions.
CAUTION
Do not use deionized water. Deionized water will
greatly shorten the life of the water reservoir
and heating element.
NOTE: Product failure caused by deionized water is not
covered by warranty.
NOTE: On the initial fill the water reservoir capacity
is 96 ounces or 3/4 of a gallon (2.8 liters).
4. Set the humidity selector to the desired level.
Set the temperature selector to the desired
temperature. See the FOOD HOLDING GUIDE
for recommendations.
Form No. FDWM-0602
On/Off Switch
Humidity Cycle Light
Low Water Indicator
Figure 7. Flav-R-Fresh Control Panel
NOTE: Temperature and humidity settings may vary
depending upon product make-up and consistency.
The temperature indicator displays the lowest
temperature pint inside the cabinet, not the
product temperature.
Allow 20 minutes to preheat a full reservoir of water.
The Flav-R-Fresh is then ready to hold foods
at the humidity and temperature selected.
The reservoir capacity permits uninterrupted operation
for approximately 3-6 hours, depending on the settings
and how frequently the door is opened. When the red
low water indicator light is lit, add water to the
reservoir. The water reservoir refill capacity is
approximately 48 ounces, or three (3) pints (1.5 liters).
Units with the Auto-Fill option are filled automatically
when the red low water indicator light comes on.
Some exterior surfaces on the Display Cabinet
will get hot. Use caution when touching these areas
to avoid injury.
To prevent any injury discontinue use if power cord
is frayed or worn.
6
Humidity Selector
Temperature Indicator
nbfehvijfhvjeivfei nbfehvijfhvjeivfei
fgjehjehjevhjevhejiivhui fgjehjehjevhjevhejiivhui
ghjilgvijfdegvfeghejghej; ghjilgvijfdegvfeghejghej;
vjfevjneko;vjek;ejnoo vjfevjneko;vjek;ejnoo
nbfehvijfhvjeivfei nbfehvijfhvjeivfei
fgjehjehjevhjevhejiivhui fgjehjehjevhjevhejiivhui
ghjilgvijfdegvfeghejghej; ghjilgvijfdegvfeghejghej;
vjfevjneko;vjek;ejnoo vjfevjneko;vjek;ejnoo
Reservoir Fill Cup
Temperature Selector
CAUTION
WARNING