Important Safety Instructions - Hatco FLAV-R-FRESH FDW-1 Installation & Operating Manual

IMPORTANT! Read the following important safety instructions to avoid personal injury or death,
and to avoid damage to the equipment or property.
WARNINGS
To prevent electric shock or injury, turn the power
switch off, unplug the unit from the power source
and allow to cool completely before performing
any maintenance or cleaning.
Plug cabinet into a properly grounded electrical
outlet of the correct voltage, size and plug
configuration. If the plug and receptacle do not
match, contact a qualified electrician to determine
the proper voltage and size and install the proper
electrical outlet.
Overfilling can cause electrical shock. Stop filling
when low-water light goes off.
To avoid any injury, turn the power off to the unit
and allow to cool before draining.
To prevent any injury discontinue use if power
cord is frayed or worn.
Only bulbs which meet or exceed N.S.F standards,
specifically designed for food holding areas
must be used. Breakage of bulbs not specially
coated could result in personal injury
and/or food contamination.
For safe and proper operation, the Display
Cabinet must be located a reasonable distance
from combustible walls and materials. If safe
distances are not maintained, discoloration
or combustion could occur.
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact
the Hatco Service Department at 800-558-0607
or 414-671-6350; fax 800-690-2966 or
International fax 414-671-3976.
This product has no "user" serviceable parts.
To avoid damage to the unit or injury to
personnel, use only Authorized Hatco Service
Agents and Genuine Hatco Parts when
service is required.

IMPORTANT SAFETY INSTRUCTIONS

Genuine Hatco Replacement Parts are
specified to operate safely in the environments
in which they are used. Some aftermarket
or generic replacement parts do not have
the characteristics that will allow them to operate
safely in Hatco equipment. It is essential to use
Hatco Replacement Parts when repairing Hatco
equipment. Failure to use Hatco Replacement
Parts may subject operators of the equipment
to hazardous electrical voltage, resulting
in electrical shock or burn.
Some exterior surfaces on the Display Cabinet
will get hot. Use caution when touching these
areas to avoid injury.
The unit must be transported in an upright
position. If laid on its side, all glass surfaces must
be secured with tape, and water must be drained
from the unit.
Locate the Display Cabinet at the proper counter
height, in an area that is convenient for use.
The location should be level to prevent the cabinet
or its contents from accidentally falling.
Unit is not weatherproof. For safe and proper
operation locate the unit indoors where
the ambient air temperature is a minimum
of 70°F (21°C).
Water Quality Requirements – Incoming water
in excess of 3.0 grains of hardness per gallon
(GPG) (.75 grains of hardness per liter) must
be treated and softened before being used. Water
containing over 3.0 GPG (.75 GPL) will decrease
the efficiency and reduce the operating life
of the unit.
Use only non-abrasive cleaners. Abrasive cleaners
could scratch the finish of your Flav-R-Fresh
Holding and Display Cabinet marring its
appearance and making it susceptible to soil
accumulation.
Do not use deionized water. Deionized water will
greatly shorten the life of the water reservoir
and heating element.
1
WARNINGS
CAUTIONS
CAUTIONS
Form No. FDWM-0602