High-Voltage Interface Cables And Connectors; 5211036 Connector Kit; 5211037 Cable Assembly - Cablescan 90 Series Setup Manual

Series 90 Setup Manual Page 19

HIGH-VOLTAGE INTERFACE CABLES AND CONNECTORS

The Series 90 high-voltage test systems use selectively loaded 96-pin DIN connectors to
interface between the test points on the scanner boards and the assembly under test. For
isolation purposes, the scanner board connectors have pins in only every-other position of the
outer two rows. This configuration produces 32 pins per connector. Therefore, two 32-pin DIN
connectors are used for each high voltage scanner board.

5211036 Connector Kit

The 5211036 connector kit is used to make high-voltage interface cables. The kit consists of the
32-pin scanner board interface DIN connector with solder tails and a connector hood. The
5211036 is used to make the 5211037 high-voltage cable assembly. See Figure 18.

5211037 Cable Assembly

The 5211037 is an eight-foot discrete wired high voltage cable assembly. It has a 32-pin male
DIN connector (5211036) on one end, and the second end is unterminated. This cable can be
used to terminate mating connectors for the assembly under test or a connector to interface to a
test fixture. See Figure 18.
Pin 1
Pin 2
5211037
Figure 18. High-voltage Cable Assembly – 5211037
5211038 Cable Assembly
The 5211038 is a 96-conductor, eight-foot, discrete-wired, high-voltage cable assembly. It uses
three, 32-conductor cable assemblies; 5211037 on one end and a 96-pin ZIF connector (plug) on
the second end. The 96-pin ZIF plug is an ITT-600 series connector. This cable is used to
interface to a test fixture.
5211088 Connector Kit
The 5211088 is a 96-pin, panel-mount ZIF receptacle that mates to the 5211038 cable assembly.
This receptacle generally is mounted on a harness board or test fixture and used to wire the
fixture. The connector kit contains a 96-pin receptacle and 100 crimp contacts.