Setting The Seal Point - Advanced Poly-Packaging T-1000 Instructions Manual

Press NEW BAG.
Since the bag now stops above the Heater Bar opening, you will have to adjust
your Seal Point and Reverse to place the Seal Point where you need it, and to
make sure Reverse doesn't pull your bags too far into the machine.
Since the bag now stops higher than normal, you may have to set a Seal Point
that is very close to, or exactly 0.00
Press MANUAL CYCLE until Bag Length Current/Last/Average are about the same
numbers. This usually takes 4 to 5 cycles.
Page 6 of 6