Table of Contents
Advertisement
REFRIGERATION LTD
When cleaning inside the unit, do not leave the front glass lifted in the aluminum
profile. This may cause the damage to the glass and is not covered by the
warranty. Please remove the glass during cleaning. (Figure 5)
Elements of equipment can corrode as result of improper use and maintenance. To
prevent damage: Do not allow contact of the with substances containing chlorine and/
or baking soda in different varieties, which destroy the protective layer and components
of the equipment (also includes various stainless steel)
6. SERVICE
6.1. Faults identification and repair
In the case of any difficulties during actuation of the equipment or during its operation, please return to the
chapters in this manual, which explain the performed operation. This aims to ensure the equipment is properly
operated. If you still experience difficulties, the following might help you solve the problem.
The equipment is not working... – Make sure that:
• Voltage and frequency are compliant with those recommended by the manufacturer.
• The unit is connected to the supply network.
• The main switch on the control panel is turned on.
The equipment is operating, but the light is off... – Make sure that:
• Light switch is turned on.
• Lamp, starting switch, or power supply of the unit is not burnt.
The equipment does not reach the proper temperature, the light is on... – Make sure that:
• The main switch is on.
• Heating temperature is properly set.
• The heater is not burnt.
Steam precipitation on the glass of the device is a normal phenomenon in case of
high relative air humidity exceeding 60% and does not require calling for service!
8
www.igloorefrigeration.com
Figure 5 Front glass disassembly
1 – Front glass
2 – Upper aluminum profile (lift guide)
3 –Lower aluminum profile (catch)
Heated Display Cases
|
Advertisement
Table of Contents
