Woods CZ2048K Operator's Manual page 41

WOODS
NOTE: Always use WOODS, Inc. replacement belts, not general purpose belts. WOODS,
Inc. belts are specially designed for use on this mower and will normally last longer.
HYDRO TRANSAXLE DRIVE BELT
1. Remove cutterdeck belt (see cutterdeck belt
replacement).
2. Disconnect wire I at clutch M. Remove bolts J
and remove torque restraint.
3. Using a ratchet with a 9/16" socket, place over
nut at location P. Use the ratchet to rotate it
enough to remove the transaxle drive belt.
4. Install a new transaxle drive belt by performing
these steps in reverse order.
5. Inspect the fans. Replace if worn or damaged.
Torque transaxle pulley nut to 28.3-41.6 ft-lbs
(38-56 Nm).
6. Reinstall cutterdeck belt (see cutterdeck belt
replacement).
BELT REPLACEMENT
41