Advertisement
Building in
30
The bridges on the connecting block can be used to create the
required connections, as indicated in these illustrations.
Check that the cabinet and the cut-out meet the dimension and
ventilation requirement
Threat the sawn ends of wooden or synthetic worktops with
sealing varnish if necessary, to prevent moisture causing the
worktop to swell.
Lay the hob upside down on the worktop.
Fit the connecting cable to the appliance in compliance with
requirements (see page 69 and 70).
Remove the protective layer from the sealing tape and apply
the tape in the groove of the aluminium profi le or on the edge
of the glass plate. Do not stick tape round the corners, but cut 4
separate pieces to seal the corners well.
Turn the hob over and lay it in the recess.
Connect the appliance to the mains. A short bleep will be heard
and all the displays will light up briefl y. The appliance is ready for
use.
Check that it works properly. If the appliance has been wrongly
connected either a bleep will sound or nothing will appear in the
displays, depending on the error.
Advertisement
