Table of Contents
Advertisement
TG6611_6612HK(e-e).book Page 31 Tuesday, May 24, 2011 3:18 PM
Error messages
Display message
Cause/solution
L The handset has lost communication with the base unit. Move
Base no power
or
No link. Reconnect
L Unplug the base unit's AC adaptor to reset the unit.
AC adaptor.
or
L The handset's registration may have been cancelled. Re-
No link.
L When "No link." is displayed during a power failure, place
L The supplied telephone line cord has not been connected yet
Check Phone Line
L Phonebook copy failed (page 19). Confirm the other handset
Failed
L The receiver's phonebook memory is full. Erase the
Incomplete
L The phonebook memory is full. Erase unwanted entries (page
Memory Full
L The call barred list memory is full. Erase unwanted entries
L A wrong type of battery such as Alkaline or Manganese was
Use rechargeable
battery.
L You must subscribe to a Caller ID service. Once you receive
You must first
subscribe to Caller
ID.
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit's
AC adaptor and turn off the handset, then reconnect the base unit's AC adaptor and turn on the
handset.
General use
Problem
Cause/solution
The handset does not turn
L Place the handset on the base unit or charger to turn on the
on even after installing
charged batteries.
closer to the base unit and try again.
Reconnect the adaptor and try again.
register the handset (page 25).
a handset on the base unit to supply power to the base unit.
or not connected properly. Check the connections (page 8).
(the receiver) is in standby mode and try again.
unwanted phonebook entries from the other handset (the
receiver) and try again.
19).
(page 24).
inserted. Use only the rechargeable Ni-MH batteries noted on
page 4, 6.
caller information after subscribing to a Caller ID service, this
message will not be displayed.
handset.
Useful Information
31
Advertisement
Table of Contents
