Page 1
Waiting position BAW-HSW Brief description – English 8104208 2018-12b [8104210]...
Page 2
Translation of the original instructions Documentation on the product For all available product documentation è www.festo.com/pk Copyright: Festo SE & Co. KG Ruiter Straße 82 73734 Esslingen Germany Internet: http://www.festo.com E-Mail: service_international@festo.com Reproduction, distribution or sale of this document or communication of its contents to others without express authorization is prohibited.
Page 3
HSW and, with a time delay, pressurisation of the double-acting actuating cylinder of the waiting position BAW-HSW moves the guide rail from the initial position (A) into the waiting position (B). When the actuating cylinder is being retracted, the pressurised swivel module pushes the guide rail into the end position (C).
Use shut-off valves in order to make the system pressureless for installation and maintenance work. Fasten the elements of the BAW-HSW as follows: – the shock absorber with lock nut 1 on the retainer – the actuating cylinder with 2 socket head screws 2 on the guide carriage.
Page 5
2 (2x) Type BAW-HSW-10 M6 x 0.5 0.4 Nm M4 x 22 3 Nm BAW-HSW-12 M8 x 1 2 Nm M5 x 25 6 Nm BAW-HSW-16 M10 x 1 3 Nm M5 x 30 6 Nm Festo BAW-HSW-... 2018-12b English...
Page 6
Fasten the tubing outside the area of movement of the handling module. Secure the tubing with the aid of cable straps to the holders of the installation kit MKRP 6 (è catalogue specifications). Festo BAW-HSW-... 2018-12b English...
Page 7
2. Fasten the lines outside the area of movement of the handling module. S Secure the lines with the aid of cable straps, etc., to the holders of the installation kit MKRP 6 (è catalogue specifications). Festo BAW-HSW-... 2018-12b English...
Page 8
2 (time delay Δt è Technical specifications). Pressurise your system slowly. Observe the commissioning instructions in the operating instructions for the handling module. Carry out a test run as described in the operating instructions for the handling module. Festo BAW-HSW-... 2018-12b English...
Page 9
3. End position: 4. Basic position: Cylinder of the waiting position Handling module swivels into retracts. upper end position. Festo BAW-HSW-... 2018-12b English...
Page 10
To set the waiting position 1. Pressurise the swivel module of the HSW and, with a delay, the actuating cylinder of the BAW-HSW. 2. Loosen the locking nut 1 of the shock absorber. 3. Turn the shock absorber (A) while at the same time holding the lock nut in place until the desired position is reached.
Page 11
Lubricate the piston Hard striking of No time delay in Actuate the actuating the cylinder actuating HSW and cylinder of the BAW-HSW BAW-HSW with a time delay to the swivel module of the HSW (è Technical specifications) Festo BAW-HSW-... 2018-12b English...